sitemap link mailform link home

Arduino Starter Set

Beitrag aktualisiert am 29. Januar 2018

Was braucht man für Arduino-Experimente?

Es gibt sehr reichhaltige Starterkits. Für den Anfang reicht der Inhalt dieser Sets absolut aus.

Externer Link Funduino Lernset Nr.4 mit UNO Controller - Kit für Arduino / 49,90 €

Leider nur im Pappkarton... sonst aber nicht schlecht.

Inhalt:
1x UNO R3 Mikrocontroller-Board (Arduino-kompatibel von Funduino), neuste Version (R3)
1x USB-Kabel für Arduino Mikrocontrollerboards
1x großes Breadboard mit 830 Steckplätzen
65 Stück Breadboard Kabel
10 Stück Breadboardkabel weiblich/weiblich (female / female), zum Anschluss von Sensoren
1x 9V Batterieklemme zum Anschluss von 9V Blocks
1x Ultraschallsensor HC-SR04
1x Bewegungsmelder HC-SR501
1x Temperatursensor TMP36GT9Z
1x Fotowiderstand 1K Ohm (Helligkeitssensor)
1x Drehpotentiometer
1x Servo
4x Taster 12mmx12mm
1x Piezo Speaker / Lautsprecher
1x Infrarot Empfänger
1x Infrarot Sender (LED)
1x LCD Modul "1602" mit blauer Beleuchtung (Version ohne Steckverbinder, Buchsenleiste zum anlöten beiliegend)
1x RGB LED (Mehrfarbige Leuchtdiode)
Je 20 Stück LED Blau, Rot, Grün, Gelb, Weiß
Je 20 Stück Widerstände 100, 200, 330, 1K Ohm, 10K Ohm
1x Diode (1N4001)
1x Transistor [TIP120]
1x Relaiskarte für Arduino
1x Infrarot Fernbedienung
1x Schrittmotor mit Treiber-Platine (ULN2003)

Oder:

Externer Link Elegoo-Kit für Arduino / 46,99 € (Aktionspreis bei Amazon)

Leider ohne Kunststoffbox...

Oder:

Externer Link Kuman Project Super Starter Kit for Arduino (mit Kunststoffbox) 30,99 €

Inhalt:

(1). Kuman UNO R3 Entwicklungsboard x1
(2). USB Kabel x1
(3). Prototyp-Erweiterungsplatine x1
(4). Mini breadboard x1
(5). 5V Schrittmotor x1
(6). 2003 Schrittmotor-Treibermodul x1
(7). Rote LED x5
(8). Grüne LED x5
(9). Gelbe LED x5
(10). Erschüttern Sensor x2
(11). Feuer Sensor x1
(12). LM35 Temperatur Sensor x1
(13). Infraroter Strahl-Empfänger x1
(14). Fotowiderstand x3
(15). Key cap x 4
(16). Key Schalter x4
(17). Nachstellbare Potentiometer x1
(18). Passive Summer(piezo Summer) x1
(19). Active Summer (tone generator) x1
(20). Jumper cap x1
(21). Grosse Breadboard x1
(22). Remote Kontrolle x 1
(23). 1602 Schirm x1
(24). Breadboard Modul x1
(25). HC-SR04 Modul x1
(26). Zubehörsbox x1
(27). DuPont Linie 1 x10pin
(28). Breadboard linie(circa) x30
(29). 8*8 dot Matrix x1
(30). 1-stellige 8-Segmentanzeige x 1
(31). 4-stellige 8-Segmentanzeige x1
(32). IC 74HC595 x1
(33). Batteriessteller x1
(34). Ohm-Widerstand 5 x 220ohm
(35). Ohm-Widerstand 5 x 330ohm
(36). Ohm Ohm-Widerstand 1K x5
(37). Ohm Ohm-Widerstand 10K x5
(38). Batterie 9V x1
(39). 40pin pin Header 2.54mm x1
(40). Drei Farben LED Modul x1
(41). Thermistoren Modul x1
(42). Touch Sensor x1
(43). CD mit Tutorial x1
(44). Plastic Box x1

Oder:

Meine Empfehlung:

Externer Link Arduino Starter Kit, Smraza Ultimate, 28,09 € (sehr viele Teile!)

Alles in robuster Kunststoff-Box!

Dieses Set lässt keine Wünsche offen:

1) UNO R3 Controller Board x1
2) LCD1602 Module ( with pin header) x1
3) Breadboard Expansion Board x1
4) Servo Motor x1
5) Stepper Motor x1
6) 830 tie-points Breadboard x1
7) Ultrasonic distance sensor x1
8) ULN2003 Stepper Motor Driver Board x1
9) Potentiometer x2
10) Photoresistor x2

11) Thermistor x1
12) Active Buzzer x1
13) Passive Buzzer x1
14) Diode Rectifier (1N4007) x2
15) 2N2222 Transistors x2

16) Yellow LED x5
17) Blue LED x5
18) Green LED x5
19) Red LED x5
20) RGB LED x1

21) Tilt Switch x1
22) Button (small) x5
23) 7-Segment Display x1
24) 4 digit 7-segment Display x1
25) IC 74HC595 x1
26) Power Supply Module x1
27) Joystick Module x1
28) DHT-11(Temperature and Humidity Sensor) x1
29)9V Battery with DC x1
30)Battery buckle x1
31) IR Receiver Module x1

32) Resistor (220R) x10
33) Resistor (1M) x10
34) Resistor (100R) x10
35) Resistor (100K) x10
36) Resistor (1K) x10
37) Resistor (2K) x10
38) Resistor (5.1K) x10
39) Resistor (10K) x10
40) Resistor (10R) x10
41) Resistor (330R) x10

42) Header (40pin) x1
43) L Shape Header (40pin) x1
44) Water Lever Sensor x1
45) USB Cable x1
46) 65*Jumper Wire x1
47) 10pin Male to Female Jumper Wires x1
48) IR remote control x1
49) Band Resistor Card x1
50) CD x1

Das riesengroße Kit, das keine Wünsche mehr offen lässt:

Externer Link Smraza Vollständige Super UNO Set mit Tutorial -> wörtlich von Amazon übernommen Kiss

In der Kunststoffbox - nur 49,99 €.

 

Anleitungen und Beschreibungen für eigene Projekte:

Externer Link https://github.com/sensebox/OER/wiki

-> Wir arbeiten mit der senseBox:edu und verwenden daher die entsprechenden Anleitungen.

Externer Link Ein LC-Display an den Arduino anschließen

Externer Link https://www.arduino.cc/en/Tutorial/LibraryExamples

Externer Link http://www.arduino-tutorial.de/

Externer Link http://starthardware.org/ (Für Kinder - sehr gut!)

Externer Link http://starthardware.org/arduino-unterrichtsmaterial/ (Für Lehrer)

.

 

Letzte Änderung:
March 23. 2023 21:04:40
«    top    »